Starting a nitro RC engine isn’t a one-size-fits-all process—different engines require different starting methods. Whether your nitro car uses a pull starter, starter box, roto start, or bump start, each system has its own advantages and best practices. In this guide, we’ll break down the most common nitro engine starting methods and how to use them effectively.
1. Pull Start (Manual Recoil Starter)
A pull cord engages a one-way bearing on the flywheel, turning the engine over until it fires.
Starting Steps:
1. Prime the engine (block exhaust & pull cord until fuel reaches the carb).
2. Attach the glow igniter to the glow plug.
3. Hold the car securely and pull the cord smoothly (no yanking!).
4. Once started, let it idle for 30 seconds before driving.
A battery-powered box with spinning rollers engages the flywheel or starter cup, cranking the engine.
Starting Steps:
1. Place the car on the starter box, aligning the flywheel with the rollers.
2. Prime the engine** (use exhaust blocking or primer bulb).
3. Connect the glow igniter.
4. Press down firmly and activate the starter box until the engine fires.
A handheld electric motor connects to a hex drive on the engine’s backplate, turning the crankshaft directly.
Starting Steps:
1. Insert the roto start shaft** into the engine’s backplate.
2. Prime the engine** (fuel in the carb).
3. Attach the glow igniter.
4. Hold the starter button** until the engine kicks over.
Troubleshooting Starting Issues
- Engine won’t turn over?** Check for a locked-up piston or low battery (if using electric start).
- Flooded engine?** Remove glow plug, crank to clear fuel, then retry.
- Weak glow plug?** Replace it—it should glow bright orange when powered.
Final Tips for Easy Starting
- Always prime the engine before starting.
- Use fresh nitro fuel (old fuel can cause hard starts).
- Keep spare glow plugs** handy.
- Let the engine warm up before full throttle.